COLLADA support for linear and angular dampening?
-
- Posts: 4
- Joined: Wed May 09, 2007 8:15 pm
COLLADA support for linear and angular dampening?
Reading through the COLLADA spec I am unable to find any support for a rigid body linear and angular dampening. Is this correct?
-
- Site Admin
- Posts: 4221
- Joined: Sun Jun 26, 2005 6:43 pm
- Location: California, USA
Re: COLLADA support for linear and angular dampening?
Indeed, you need to use an <extra> or custom COLLADA profile for this.micahp wrote:Reading through the COLLADA spec I am unable to find any support for a rigid body linear and angular dampening. Is this correct?
Thanks,
Erwin