Unexplained behaviour with rigidbody applyImpulse

Apollo
Posts: 17
Joined: Wed Dec 21, 2016 1:15 pm

Re: Unexplained behaviour with rigidbody applyImpulse

Post by Apollo » Thu May 16, 2019 8:59 pm

drleviathan wrote:
Thu May 16, 2019 8:33 pm
Yes, the values look better, and if it is working well for you then great! You have a good reference point now. You can make tuning deviations from there.

Low angular damping is better. My advice: keep dialing it down until it is bad, then dial it back to where it was last good.
Thank you for all of the help! I'll definitely keep tweaking the values, I test things a lot so I'll try and fine tune things to make it the best I can

Post Reply