About catheter virtualiza​tion

Job seekers and recruitment for game physics developers.
Post Reply
Posts: 8
Joined: Wed Dec 14, 2011 11:46 am

About catheter virtualiza​tion

Post by wolves86 »

Dear Mr/Mrs:

I have problems that I don't know how to virtualize the catheter using Bullet. The catheter is not very thick and is a little rigid. I have to vitualize it in blood vessel environment. And when given a force from the end of the catheter, the catheter will deform. I don't know how to do it. Could you give me some help. Thank you very much!
Posts: 65
Joined: Fri May 13, 2011 1:11 pm

Re: About catheter virtualiza​tion

Post by Karrok »

You could perhaps try and emulate it using cylinders with limited height (and radius = catheder radius).

Then make a "string" of these cylinders and put the correct joint between them with whatever joint parameters you require (most likely a ball-joint)

It would look something like this:
cathedersimulation.png (2.18 KiB) Viewed 8414 times
Then just fiddle with cylinder height, distance between cylinders and joint parameters.
Post Reply